It's About Time - Clock Repair Rich Straub, Owner

06/21/2026

If you have a grandfather (floor) clock please call to set up an time for me to come over and look at it.

06/21/2026

If you have a mantle or wall clock please call before coming over as I go out on grandfather (floor) clock service calls.

07/06/2025

07/06/2025

This is a Howard Miller battery operated floor clock that I installed a new battery pendulum driver and separated battery chiming movement.

03/16/2023

This is a clock kit that my dad did an excellent job of building in 1978. I cleaned and bushed the movement in 1994 and just cleaned and bushed it again. Hopefully it will be handed down to his grandkids and beyond.

03/12/2023

This is a one of a kind hand made Grandfather Clock, not a kit. It was made over forty years ago. Someone else worked on the movement and screwed it up. Had to polish all wheel pinions. Replace most of the bushings that were just put in. The bushing for the first wheel in the time train on the front plate wasn't located properly, which required installing an oversized bushing and installing the correct bushing inside the oversized bushing to correct the problem. There was also several adjustments that had to be done that were not done on the original repair. I then put the movement on test for several weeks to make sure that everything was satisfactory and reinstalled the movement. This clock should give many years of trouble free service.

02/10/2023

This Cuckoo Clock looks brand new. It was purchased in Germany over 10 years ago. It only ran for a short time before the owner gave up on it because it wouldn't keep running. The guy who made this must have been having a bad day. The holes in the bottom of the clock were not properly located, the chain for the music box was routed incorrectly and was to short. The lift levers for the bellows weren't adjusted correctly. All this needed to be corrected as well as cleaning the gummed up oil in the movement and music box from sitting for 10 years.

03/13/2021

This was a owner attempted repair. The front winding arbor support was drilled over sized and a steel collar was forced into it. The rear winding arbor pivot in the front movement plate was drilled out over three times its original size. I had to solder in over sized bushings.

02/12/2021

This is an old electric clock converted to a battery movement.

07/19/2020

An other one of a kind hand made shelf clock with an old Urgos movement. Movement has been cleaned and bushed. Everyone who has looked at this clock has shown great interest in it.